Modular Clean Room Panels

Providing and maintaining clean area in most of the pharma and healthcare industry is today’s requirement. With fully equipped facility to provide these partition panels as per universally acceptable norms.

Panels in GI powder coated construction, SS 304 construction is available. The closing sections are complete in aluminium construction and are hermetically sealed. The infill is high density PUF or can be with Rockwool depending on the requirement of end user. The accessories provided are in aluminium construction for making it a foolproof design.

Description Conventional construction Modular Construction
Weight 300 Kg/Sq.mtr. 25 Kg/Sq.mtr.
Walkable ceiling 500 Kg/Sq.mtr.(RCC) 45 Kg/Sq.mtr.
Load Bearing capacity - 150 Kg/Sq.mtr.
Surface finish Average smooth RA=0.6 microns
Thermal conductivity 0.35 0.12
Condensation Normal No condensation
Particle shedding Yes No
Shipping in case of impact Surface gets damaged Minimum
Moisture Retention Very common Normal
Cost to be considered Basic brick wall
Construction cost
Plastering cost
Epoxy painting cost
Only panels

Specifications for Sandwich Wall / Ceiling Panels

Sandwich type Wall Panel made out of GI powder coated sheet on both side and inside filled with EPS/Poly urethane foam of specified thickness.

  • Normal panel Width : 1200 mm (or as per site condition)
  • Thickness : 40 - 100mm
  • MOC : GI pre coated / powder coated
  • GI sheet Thickness: 20 / 22 / 24 gauge
  • Insulation : Poly Urethane Foam
  • Density: 40 Kg/m3
  • Joint : Using al. section for interlocking & leveling of panels.
  • Sealing of Joints : Using silicon sealant of approved color.
  • Bottom : Fixed with aluminium angular connection
  • Top : Fixed hanger support from RCC slab / MS structural steel grid
  • Mode of Measurement : Sq. Mtr. (for panels)
  • View Panels : Necessary view panels should be provided as per details provided in design
  • Coving : All joint between floor and wall, wall and wall and wall and ceiling shall be covered with aluminium powder coated coving section of radius min.50 mm. Joint between coving and surface shall be sealed with silicon sealant of approved colour.
  • Mode of Measurement : R. Mtr. (Running Meter) (for coving)

Advantages of Modular Plants

  • Fast building technology – allowing latest start
  • Accelerated schedule
  • Parallel activities which are normally in sequence.
  • 24/7 shift work possible
  • Weather independent since indoor fabrication
  • Movable asset
  • Validation activities off – site
  • Reduction in site construction infrastructure
  • Reduction in site construction labour requirement
  • Single window managed
  • Future site modifications easier by changing complete module if required.
  • Cost efficient